Bowling Lane Gutter Width

A maximum 40 1000th inch will be permitted in levelness and depth depression.

Bowling lane gutter width.

This is because the width of each individual lane sits at 3 feet and 6 inches while the length of the lane happens to be a whopping 60 feet long. Lane surface the surface must be free of all continuous grooves. The surface of the lane must be free of contiguous grooves or ridges 40 1000 tolerance for crosswise tilt crowns and depressions. The bowling lane is 39 boards wide totaling 41 5 inches making each board 1 06 inches in width.

The lane plus the gutters shall not be less than 60 inches nor more than 60 1 4 inches wide. Its width according to the guidelines set by the international bowling federation is 41 5 in i e. The center of the head pin spot is 60 feet plus or minus 1 2 to the foul line. For four lane projects the minimum width required is 22 8.

Lane width the lane shall be between 41 and 42 inches in width. The gutter width is 9 1 4 in width. The lane is 41 1 2 in width. Bowling lane minimum widths the diagrams shown in the pdf depict measurements required for a pair of lanes requires 11 6.

On the left and right side of the lane are two gutters which sit lowered from the lane surface by 1 7 8. The lane surface must also have a lengthwise tilt tolerance of 40 1000. The gutter is 1 7 8 beneath the lane surface. The width is measured from gutter tip to gutter tip while the length starts at the foul line and ends at the head pin.

The lane is made of tongue and grooved bed stock typically laid on edge or made of a synthetic material giving the appearance of boards sitting on their edges.